How to install an induction lamp? What are the precautions for installing an induction lamp? 13 major precautions when installing an induction lamp:
1. The power must be cut off during installation to ensure safety.
2. Confirm that the wiring port is correct before powering up.
3. If abnormal operation (self-extinguishing, flashing) is found, the power should be turned off immediately and removed by a professional. .
4. The bottom of the bulb (coupler base) and the fixture of the luminaire must be firmly connected and in close contact to ensure good heat dissipation.
5. The shield between the bulb and the HF generator should not be lengthened or shortened.
6. The bulb and HF generator are required to be grounded separately during installation.
7. Regardless of the type of luminaire used, the luminaire housing must be grounded.
8. The light source should not be lit for more than 15 minutes when it is not connected to the lamp (so that the lamp itself acts as a heat sink).
9. When the bulb is lit or just turned off, do not touch the bulb directly with your hand to avoid burns.
10. Occasionally, the electrodeless lamp does not illuminate, or it turns off after lighting. Please check the heat sink of the lamp.
11. If the generator is installed in a closed electrical box, the top cover of the generator can be removed.
12. The coupler and HF generator cannot be changed at will.
13. Both the induction lamp and the high frequency generator cannot be mounted on a luminaire without a heat sink.
Antique Shower Set,Master Shower Set,Wall Showers Sets
Zunqiao Technology Co., Ltd. , http://www.sinyo-sinkfaucet.com