Pivot End Stops HAAS AXIS Cable Railing Components Installation
Sure! Here’s the rewritten content in English:
---
In this blog post, we’re diving deep into the details of installing HAAS AXIS Pivot End Stops. Whether you're a beginner or just looking to refresh your knowledge, this guide will walk you through every step of the process.
To start, you’ll need to mark your post. Grab your marking template and carefully mark the end or corner post where the screw pilot holes for your AXIS pivot end stops will go. This step is crucial as it sets the foundation for the entire installation.
Once your marks are in place, take out your drill and ensure it’s set to its highest speed setting. Using a 1/8" drill bit, carefully drill pilot holes into your post at each marked point, going about 2 inches deep. Be sure to repeat this for all the marks on the post.
After drilling your pilot holes, it’s time to gather your AXIS pivot end stop components. These include the AXIS pivot receiver, a stainless-steel decking screw, an AXIS pivot eye, an AXIS swage stud, and an AXIS pivot receiver pin. Familiarize yourself with these parts before proceeding.
Next, let’s focus on mounting the AXIS pivot receivers to your post. Begin by inserting a T-20 star bit into your drill and adjusting the drill to its lowest speed setting. Pass the stainless-steel mounting screw through the AXIS pivot receiver and gently drive it into the post. Keep drilling until the receiver fits snugly against the post.
Use a flathead screwdriver to adjust the orientation of the receiver as needed for the run. Repeat this process for all the remaining pivot receivers at the post.
Now that your receivers are securely mounted, it’s time to attach the precut cables to the receivers. First, locate the AXIS pivot receiver eyes and swage studs, then thread them together. Insert each precut cable into the AXIS swage studs, ensuring the cable is seated properly at the back of the swage cavity.
With the swage studs secured at the end of each cable, use your swaging tool to complete the final assembly. Align the swage stud with the die of the swager, close the handles to make the first swage, then slightly open the handles, rotate the stud 90 degrees, and make the second and final swage. Repeat this process for all the cables and swage studs in the run.
Finally, insert the AXIS swage stud and pivot receiver eye into the receiver slot and secure it in place with the pivot receiver pin. Use a flathead screwdriver to tighten the pin firmly.
Once everything is tightened, your installation is complete! You can now attach the cable to the tensioning fitting at the other end of the run.
---
This should give readers a comprehensive understanding of the installation process while maintaining a natural, conversational tone.
Precise accessory is a kind of high-precision hardware turning part processed by lathe and other machine tools, which is characterized by high precision, precision and small size
It is a very common product in our hardware processing parts industry and is widely used. The basic precision can reach 0.01mm-0.1mm. The products include steel, aluminum alloy, brass, environment-friendly iron, stainless steel and other precision CNC machining lathe parts of different sizes and shapes
Advantages of precision turning parts:
High technical requirements, beautiful appearance and good product quality
Scope of application:
Mechanical equipment, computers, mobile phones, electrical appliances, fans, cameras, high-end electronics, toys, instruments, automobiles, new energy, optical fiber communications, photographic stage equipment and other products.
