Wall decoration is generally inseparable from latex paint, but everyone knows the wall paint construction process ? Today Xiaobian is here to introduce the construction technology of latex paint on the wall. I hope to help everyone understand the construction technology of the wall paint .
First, the grassroots processing
The purpose of the primary treatment of the coating project is to remove the peeling, loosening, and bulging of the wall surface first, and remove any dust, dirt, mortar, etc. remaining on the surface of the primary layer.
Second, repair putty
Putty is a kind of thick paste paint, which is an indispensable product in the paint painting construction process. Use water-gypsum to level the recessed areas on the wall, etc., and after drying, use a No. 1 sandpaper to flatten the protrusions and clean the attached dust.
Third, putty
Putty is also an indispensable step in the construction process. The construction process of scraping putty is generally three times, depending on the flatness of the wall. The mix ratio according to the putty is the weight ratio. The first pass was done with a rubber squeegee, horizontally full of squeegees, and neat; waiting for drying and grinding and then starting the second pass, it was repeated until the third pass, and the construction of the putty was completed.
Fourth, apply the first thin emulsion paint
In the construction process flow, the paint is first brushed on the wall behind the roof. When the wall is brushed, it should be lifted up and down, and then wipe the wall dust with cloth. Emulsion paints are generally lined and brushed. Dilute with water and drain evenly. After drying, replace putty and clean.
Fifth, apply the second emulsion thin paint
The construction process is the same as the first pass, but it is not advisable to add water in order to prevent the bottom from being exposed. After drying, the small trowel and row of pens on the wall should be polished off with fine sandpaper. It is best to clean it. In this way, all the matters of the coating construction process can be completed by repeating the construction process until the third pass.
Six, apply the third thin emulsion paint
The third pass is the same as the second pass, but the latex dries faster and the speed is faster. When the brushing starts, it starts from scratch and is brushed to the other end.
Concluding remark: In the wall paint construction process not only need to pay attention to each step of the method, but also need to pay attention to the preparation of the appropriate milk, in the process of construction process, careful and careful to ensure the integrity. The above about the wall paint construction process is briefly introduced here, and I hope to help you. For more information, please visit this website. Stay tuned.
Wall paint
Agricultural Chains:
We have many kinds of agricultural chain products
including the applicable standards from the occident grain combine
harvester series.corn harvester to Japanese series medium &small
type rice harvester and its special agricultural chains. We can also
offer the specific chain solutions on customer request.
With the experience of long time agricultural chain production and being an OEM supplier, we have accumulated rich
experiences of agricultural chain development.manufacture and site
management.Our agricultural chain products can meet different
operational requirements in various conditions by different material
selection and heat treatment methods. We can offer quality chain
products. Borine' Agricultural Chains are made with Chrome steel Pins
and 40Mn Plates, all chains are all by inspected strictly before
shipping.
Agricultural Chain,Agricultural Roller Chain,Agricultural Chains
Ningbo Borine Machinery Co.,Ltd. , https://www.borine-agroparts.com