The wall tiles in home renovation are one of the essential decoration materials, and the paving and construction techniques of the tiles are very particular. A good craft can not only make your interior space smart and smart, but also save you a lot of money. Next Xiaobian will introduce the methods and construction techniques for wall tiles and tiles .
1. First, tiles should be laid up from the bottom up, and one wall can not be affixed to the top, the seam is generally 1 to 3 mm; Second, before the paving, first deal with the formation of wall tiles to deal with cracks; Third, bonding materials The smear should be slightly higher in the middle than it is around, and use a rubber hammer to strike the surface to fix it. This will prevent air from accumulating in the adhesive layer. At the same time to carry out the level of testing; Fourth, the adhesive material to be stirred properly, the general wall cement and sand ratio of 1:4, the ratio of ground cement and sand 1:3
2. Wall tiles should be tied. There are some civil grounds that are uneven. In this case, everyone should use the cement mortar to level uneven areas. When laying, different colored tiles (darker colors) can be used to frame the surroundings while the tiles in the frame are lighter. Of course, the floor of the kitchen and the toilet must have an inclination. This is to facilitate drainage.
3. Another thing to pay attention to is the treatment of the waterproof layer. The walls in the kitchen and toilet areas should be highly noted. Because replacing the tiles usually damages the original cement pad waterproof layer. The remedy is to apply a layer of bituminous waterproofing before plastering. Tiles filled with white cement should also be filled.
4. Wall tile surface to be flat, the angle should be accurate, the interface to the line; tiles in the water before use should be soaked for half a day; the toilet floor should have a suitable slope, can not use the water behind the tile interface white cement after cleaning white cement with rattan brush , Do not leave cement on the brick surface; floor tiles should be covered with cardboard, etc., and walk on the brick surface for at least 24 hours.
Editor's summary: The method and construction process of wall tiles are introduced here. For more information, you can follow this site information.
Tile Tile Tile Tile Kitchen Tile
Baoji zhipu non-ferrous metal processing co., LTD.Main processing single crystal furnace, vacuum furnace, sapphire furnace accessories, thermal field, such as molybdenum, tungsten, tantalum, niobium, tungsten bars, tungsten, tungsten bars, tungsten bars, tungsten wire, tungsten tyra Tungsten Wire, Tungsten Tube, foil, tungsten, Tungsten Plate and hook foil, tungsten, molybdenum rods, tungsten, molybdenum bars, molybdenum rod, professional custom-made all kinds of tungsten, molybdenum, tantalum, niobium, such as thermal field parts, Tungsten Boat , tungsten, tungsten seed crystal chuck, tungsten seed crystal clip, tantalum, tungsten, tantalum cathode plate temperature instruments, pressure sensing device Tantalum Diaphragm, diaphragm and other parts processing, domestic use most the high grade raw material, equipped with advanced equipment and professional production team, can be customized according to requirements of various materials of tungsten products, welcome to inquire, looking forward to your cooperation!
Tungsten Wire
Dia 2.5 Tungsten Rope,Tungsten Wire,Tungsten Rope
Baoji Zhipu Non-Ferrous Metals Processing Co., Ltd. , http://www.czpmow.com